It is probably safe to ignore them. I have already contacted my broadband company and told them that I would like to be issued additional IP addresses and they have granted my request. A few very scattered thoughts: Additionally when I run netconfig and give eth0 a static address the address does not stick when I attempt to verify ifconfig eth0 As you can see I need help. All times are GMT
|Date Added:||14 August 2011|
|File Size:||7.46 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The driver makes a lot of noise about this condition because the author considers it a manufacturing defect.
Note that the baseTX media type is only available if supported by the adapter. A few very liunx thoughts: If you power down your system prior to booting FreeBSD, the card should be configured correctly.
After all of this I am still unable to llinux out to the internet on my linux box. To avoid getting caught in an infinite wait loop, the driver only polls the bit for a finite number of times before giving up, at which point it issues this message.
All times are GMT You are currently viewing LQ as a guest.
For whatever the reason, the ‘MII available’ bit in the media options register on this particular equipment is not set, even though it should be the 3cTX always uses an external PHY transceiver. Having a problem linu in?
Join our community today! Help would be appreciated. Note that registered lonux see fewer ads, and ContentLink is completely disabled once you log in.
To give an update: The xl driver supports the following media options: That module would be the 3c90x, not 3c50x The mediaopt option can also be used to c3905c either full-duplex or half-duplex modes. I will greatly appreciate any help I can get.
I verified on my Windows 2k machine that I have the ability to recieve additional IP addresses, through my hub and cable modem.
[SOLVED] Network driver issue – 3Com 3cTX
If you see this message at boot time and the driver fails to attach the device as a network interface, you will have to perform second warm boot to have the device properly configured. Note that this condition only occurs when warm booting from another operating system. If you need to reset your password, click here.
Find More Posts by Jon. The 3cB loses all of its PCI configuration in the D3 state, so if the BIOS does not set it back to full power mode in time, it will not be able to configure it correctly. The driver tries to detect this condition and bring the adapter back to the D0 full power state, but this may not be enough to return the driver to a fully operational condition. The 3cB adapters have built-in autonegotiation logic 39c05c onto the MII for compatibility with previous drivers.
I have already contacted my broadband company and told them that I would like to be issued additional IP addresses and they have granted my request. The problem I am having is: This message may be 3c9005c during driver initialization on slower machines. Registration is quick, simple and absolutely free. For more advanced trainees it can be a desktop reference, and a collection of the base knowledge needed to proceed with system and network administration.
If you see this message but the driver continues to function normally, the message can probably be ignored.
Are you new to LinuxQuestions. Linux – Networking This forum is for any issue related to networks or networking. If you’d like to contribute content, let us know. Please visit this page to clear all LQ-related cookies.
Find More Posts by Ajentsmith.